Heavy Duty Modular Hole Transfer Tool

Stop wasting expensive materials on bad measurements! Transfer hole centers, pipe coordinates, and electrical box layouts instantly with this heavy-duty, multi-joint layout tool.

This is a professional, high-precision layout template gauge designed for tilers, drywall installers (plasterboard/Rigips), carpenters, plumbers, and DIY enthusiasts. It is NOT just for tiles! Whether you need to cut a perfect hole in a ceramic gres tile, a drywall sheet, an OSB wooden panel, or the back of a kitchen cabinet, this tool is your ultimate job-site solution.

If you've ever struggled to measure the exact location of a water pipe, a protruding electrical cable, or an outlet box near a wall corner, this tool will save you hours of frustration. Based on a dynamic multi-joint arm system, it lets you perfectly lock the exact position on the wall and transfer it to your workpiece in seconds with zero math and zero errors.

The Wolf Click Hybrid Design Philosophy:

Most 3D-printed tools fail on real construction sites because plastic joints slip or snap under pressure. This tool belongs to our robust Wolf Click modular system. Every joint locks using standard metal carriage bolts embedded in custom anti-slip hex pockets. You can crank down the metal wing nuts as hard as needed to secure your setup with absolutely zero slipping.

Key Features:

• Perfect Edge Alignment: The integrated L-shaped base square hooks onto any tile or wall edge for a reliable, square reference point.
• Precision Target Centering: The alignment head features a large circular opening with 4 integrated crosshair notches to center perfectly over round cutouts, pipes, or electrical boxes.
• Unlimited Reach & Flexibility: Multi-linked slots allow you to extend, pivot, and articulate the arm to reach tight corners or complex angles.
• 100% Support-Free Printing: Designed from the ground up to lay completely flat on your print bed—zero wasted filament, zero messy supports.

Hardware Needed (Crucial for Assembly):

• 3x M6 Carriage Bolts: Length 16mm - 20mm (ideal for the hex anti-slip pockets).
• 3x M6 Wing Nuts: For quick, toolless locking and maximum pressure on site.
• 3x M6 Metal Washers: CRITICAL! Always use a washer under the wing nut to protect the printed arms from friction and distribute the clamping force perfectly without damaging the plastic.