Search models, users, collections, and posts
War Benchy (NO AMS)
IP Report
This model is created by Image to 3D
Make Your Model
Print Profile(1)
0.25mm layer, 2 walls, 10% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
0
1
0
0
1
1
Released
Description
War Benchy!
This profile is tuned for a strong, clean Benchy with a good balance of strength, quality, and print time, the settings I put in slicer were to give it a rough texture but, feel free to adjust the settings to better suit your setup.
Print Stats
- ⏱️ Print Time: 96 min
- ⚖️ Filament: 51.09 g
- 💪Strong and Durable
Attention!
The supports can be very difficult to remove! But if you have a pair of plyers or something that can get in small spaces e.g. knife, fork... then your sweet as!
Results may vary depending on your printer, filament, and calibration.
If this profile works well for you, a like, download, or boost is always appreciated. Happy printing!
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)