Pistelle X68 Grip Extender

Here's a little grip extender for a Pistelle X68 launcher. Looks great and covers up that ugly little gas canister that sticks out of the bottom of the grip. Designed and tested to be a perfect fit when made from TPU. I chose TPU for it's toughness and durability and abrasion resistance. I made it for a buddy at work so for his I used some fancy Roamr foaming TPU filament from Sirayatech, but if I was making this just for me some standard TPU would work just fine and be just as tough :) I need to try some TPU gf from them as well :) This looks nice and seamless too once the canister is popped. It'll sit square against the grip and you won't see that gap :)

It's important that you take the cap off and press it into the grip extender separate from the launcher, and without the gas canister charged and the weapon loaded for obvious reasons :) Once you've press the cap into the extender and verified it fits nice tight, thread the cap and extender back onto the grip, being careful not to puncture a canister if you have one in :) You should be able to rotate the grip extender into perfect alignment :) But it should be a snug enough fit not to move unless you force it. You could also use some glue in the hole to totally hold it on 👍

Here's a link to the exact filament I used if you want it to look real fancy :) Amazon.com: Siraya Tech Roamr TPU Air HR 80A Filament, 48-50% High Rebound, Foaming Flexible 3D Printer Filament, 64A-80A Variable Hardness, Matte Finish for Footwear, Midsoles, and Orthotics (800g, Noir) : Industrial & Scientific

Anyways hope you like this and let me know if you have any issues printing :)

Enjoy! 👍