Search models, users, collections, and posts
Adafruit I2C 1" x 0.7" case with Deutch DTM dock
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 5 walls, 30% infill
Designer
2.4 h
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
Rework of the simple snap case so same tight fit for the little PCB.
Sturdy case with screw holes that are square to the sensor. Using a DTM Deutsch connector makes it easy to connect and disconnect.
I use this for my openplotter IMU.
You need a 4 pin DTM connector and building the stemma QT wire to the DTM connector is a bit tricky. Hopefully the pictures are descriptive enough
There is room in the design for a gasket but it's too unsupported for TPU so I'd need to figure out a silicone mold but that hasn't happen yet.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)