Search models, users, collections, and posts
Fidget ball spring accessory, rubber band free alternative
IP Report
GIF
GIF
GIF
GIF
GIF
Print Profile(2)
Note the plate layout for 0.16mm layer height, 2 walls, 15% infill
Designer
9.2 h
4 plates
Remember to check the pre-arranged plates, 0.16mm layer height, 2 walls, 15% infill
Designer
5.6 h
4 plates
Open in Bambu Studio
Boost
3
11
1
0
5
1
Released
Description
Content has been automatically translated.
I made a spring, a fidget ball spring accessory, a rubber band free alternative, it is recommended to print with harder materials for better rebound.
I also optimized the one-piece design of this Type A sphere; everyone should try this one-piece design to see if it works well~
Introduction below
The upper part is a single piece, and the lower part is assembled in the same way.
Print in Place with no supports! The upper and lower halves each have minimal support.
When newly printed, it might be a bit tight,bend it a few times and it will become smooth~
Boost Me (for free)
It's tough~
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)