Search models, users, collections, and posts
PVS night vision googles
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
7.3 h
6 plates
Mount
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
5
7
5
0
3
3
Released
Description
Hello, this is PVS night vision googles dummy model it is based on PVS 69. I design to fit M3 screws. Below the heading there is assembly guide if you have problems to assembly some part let me know in comments I will help you :).
Hardwere:
M3 screws - 4x
M3 nuts -4x
Superglue -1x
This is the link to orginal PVS - https://www.printables.com/model/568458-pvs-69-alpha-11/files
Assembly guide:
1. Remove the supports from all parts. In this picture i used knife to remove the supports
2. Burn with a lighter the holes inside the print for about 1.5s
3. Push the object from inside and use superglue to attach the the round object
3.1 It should look like this
4. Grab second base and attach the screws
5. Screw the screwes until the end and at the end attach the nuts
6. Slide the mount and use superglue to glue mount the nvg mount
7. Read text in picture and do it twice ( the parts that you screw are screwed in different ways left or right soo try both of ways to do it)
8. Screw ocluar into base and add the nut at the back and do it twice
9. ALL done!!!
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)