Impo-psicle Firecracker Passthrough V2

BEFORE YOU PRINT******* Prime tower IS enabled. The prime tower is for even colour changes, if you do not want the prime tower simply DISABLE it in print settings.

Updated version 2 has a print separate stick for strength against breakage.

I have also included an optional plate in the profile with the popsicle split to parts. 

PLEASE NOTE: Since tolerances are very tight, printing in parts may have undesirable outcomes in terms of fit.

MAKE SURE your filament is properly calibrated.

UPDATES: The stick has been separated to print apart from the model for strength. The base has been updated as well to be more of a rest instead of the “Snap in fit” of the previous version. Print in parts is now included in the print profile.

ASSEMBLY: The stick and popsicle have alignment arrows to show which way it goes in the slot. it IS a tight fit and may require a bit of a tap in. if it's a bit loose on your print, add a dab of superglue to hold it in.

Not just another Impossible Passthrough. Introducing the “Impo-psicle” Passthrough Firecracker Edition Version 2!

Looking for something new? Unique? Not been done before? well here it is!

the Original Popsicle Passthrough Fidget with melting base for your desktop, or anywhere you choose!

This is a Print in Place model. Optemized for lowest material usage, but you can up the infill % if you choose.

The print can get dicey with small first layer contact points, so adding an outer brim to the popsicle may be needed,

I recommend using the profile provided to print the model for this reason. Brim not required with “Supertack Plate”

Tested to print up to 12 at once with 12 bases on another plate.

Follow me for more to come! Several more Impo-psicles are already waiting to be tested!

.2mm Layer

2 Walls

5% Gyroid Infill

Only 2 colour changes for minimal waste!

No Support

Print in Place

Outer Brim (Popsicle Only without Supertack plate)

Tolerances might be tight at first on the popsicle, but will loosen with use.