Search models, users, collections, and posts
Beagle Camera Mount – AD5X
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1 h
1 plate
Open in Bambu Studio
Boost
1
4
0
0
1
0
Released
Description
Overview:
I had an extra Beagle V2 camera left over from an old Ender 3 Pro that I added to my FlashForge AD5X. I designed this mount to screw into the left front frame to get a good aerial view of the print bed. I used two M3x8 screws and nuts to secure it.
The camera can be added to Klipper very easily assuming you have ZMod installed on the printer. It may also work within Orca Flashforge, but I haven’t tested that.
Printing:
Can be printed in most filaments for an open frame, but use high-temp filament such as ASA if used in an enclosure. No supports required if printed in the orientation shown.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)