Giant 1.4m Simple Musket (Prop / LARP / Cosplay)

Looking for an impressive, massive prop that won't break the bank or use up all your filament? This is a giant 1.4-meter (approx. 55 inches) musket designed specifically to be large, robust, and efficient to print!

It is absolutely perfect for LARP, cosplay, theater, or just as an awesome display piece.

As seen in the pictures, its massive scale makes it look incredible in person, standing even taller than a standard broom!

🎯 Design Philosophy

Please note that this design is not historically accurate. It was deliberately designed with a clean, simple look. This makes it much easier to print, less prone to failures, and gives it a sleek, stylized appearance that looks fantastic from afar and up close.

📐 Print Settings & Filament Savings

Despite its enormous 1.4m size, this model is highly optimized to save material:

• Infill: Only 10% infill is needed! It provides more than enough structural strength while keeping the model lightweight.
• Filament Used: Just under 700g of filament in total for the entire 1.4-meter print!
• Supports: Minimal supports needed for certain parts

🛠️ Assembly Instructions

Assembly is very straightforward as the musket is split into easily printable segments:

1. Glue: Use a high-quality PLA glue (like superglue/cyanoacrylate or specialized plastic weld) to join the individual sections together.
2. Pro Tip for Alignment: As shown in the pictures, I highly recommend using duct tape (Panzertape) or masking tape to tightly hold the parts together while the glue cures. Once the glue is fully dried, you can simply peel the tape off without any residue!

If you like this model, please leave a download, a rating, or upload your makes! Happy printing!