T50 Tank - Board Game Series

<Board Game Miniature Collection>--<Warship Collection>--<Aircraft Collection>--<Vehicle-Tank Collection>--<Aerospace Collection>

T50 Tank - Board Game Series

The turret can rotate 360 degrees for stress relief.

Suitable for various small scenes such as board games, Red Alert, and WWII.

One-click printing via mobile APP, compatible with all models, only 1g of material needed.

Printing Tips:
Build plate: Use a textured PEI plate.
Filament: PLA
Layer height: 0.08 / 0.12 mm
Outer walls: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Due to material shrinkage and printing tolerances, some sanding and gluing may be required. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI build plate to ensure good adhesion, and ensure your filament is dry.
Special thanks to all friends for your attention, likes, downloads, and support!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.08 /0.12mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!