Skadis Holder for Kaiweets HT118A Multimeter

Since my Kaiweets HT118A was constantly lying around on the workbench, a sensible storage solution was needed.

This holder was specifically designed for the Kaiweets HT118A and can be directly hung into an IKEA Skadis pegboard.

The multimeter is held centrally in the receptacle.

The side guides engage with the device's test probe holder, providing additional stability.

This prevents twisting or wobbling in the holder.

To insert, the multimeter is placed at the top and then gently pushed downwards until the test probe holder snaps into place. This ensures the device sits securely in the holder and cannot accidentally fall out.

An additional stop in the lower area ensures a defined fit and relieves stress on the actual suspension.

The design was deliberately kept simple and robust. No moving parts, no additional components – just print, assemble, and use.

Features

• Suitable for the Kaiweets HT118A
• Tight fit on IKEA Skadis for minimal play
• Additional stabilization via the test probe holder
• Locking by snapping in the test probe receptacle
• Secure hold with easy removal
• Robust and simple design

Print Instructions

The holder requires support structures. Due to the geometry of the receptacle and the Skadis hooks, this is unfortunately unavoidable.

Recommended print settings:

• Layer height: 0.20 mm
• 3–4 walls
• 15–25% infill
• Material: PLA or PETG
• Activate support structures

The holder was developed and tested in PLA. PETG should also work without issues.