Cap TFT-2.8 - Display Expansion for Cardputer ADV

Cap TFT-2.8 - 2.8-inch screen expansion for Cardputer ADV

Cap TFT-2.8 is a screen expansion module designed for Cardputer ADV, integrating a 2.8-inch ILI9341 screen (320x240)

BOM List

1. 2.8-inch ILI9341 screen
2. 3D printed casing C1
3. 3D printed casing D2
4. 3D printed casing R1
5. 3D printed casing L1
6. 3D printed casing D1
7. 3D printed casing S1
8. 2.54mm 2x7P double-row straight pin header
9. M2x5 socket head cap screws 3 pcs
10. M2x4 flat head socket screws 2 pcs

Assembly Instructions

Cut off the PCB on the right side of the screen

Remove the pin header and SD card slot on the back of the screen, attach double-sided tape to the left edge on the back of the screen, and connect the screen and pin header with thin wires as shown in the diagram, it is recommended to use cables with an outer diameter of 0.65mm, for wiring definition, please refer to https://github.com/AndyAiCardputer/zx-spectrum-cardputer-ili9341

Install the screen onto D1

Use 2 M2x4 flat head socket screws to install D2 onto D1

Install the pin header onto S1

Assemble C1 and S1 using 1 M2x5 socket head cap screw

Install L1 and R1 onto D1

Use 2 M2x5 socket head cap screws to install L1 and R1 onto S1

Assembly completed

Credits

This expansion is inspired by the display modification enclosure kit designed by AndyAiCardputer for Cardputer ADV, project address: https://makerworld.com/en/models/2795834-cardputer-adv-xl-external-2-8-display-mod