Retro Desktop Speaker Enclosure (T6300 Inspired)

Retro Ribbed Speaker Enclosure for Creative Inspire T6300

Give the original Creative Inspire T6300 satellite speakers a completely new look with this custom 3D-printed enclosure.

The model reuses the original speaker driver and cable while replacing the factory housing with a rounded retro-inspired design featuring an integrated ribbed front grill.

Two sizes are included:

Standard Version

• Enclosure size: 85 × 88 × 78.2 mm
• Back cover: 64 × 54 mm

XL Version

• Enclosure size: 95 × 98 × 98 mm
• Back cover: 74.7 × 74.7 mm

Both versions use the same original Creative Inspire T6300 speaker driver.

Speaker Mounting Dimensions

• Inner speaker recess: Ø59 mm
• Front sound opening: Ø50.6 mm
• Distance between speaker mounting holes: 65 mm
• Cable opening: Ø3.5 mm

Features

• Designed around the original Creative Inspire T6300 speaker driver
• Standard and XL versions included
• Integrated ribbed front grill
• Rounded retro-inspired design
• Removable rear cover
• Rear cable exit
• Detachable press-fit feet
• Internal mounting points for the back cover
• Suitable for PLA or PETG

Required Parts

• Original Creative Inspire T6300 speaker driver
• Original speaker cable
• 4 × M3 heat-set inserts, approximately Ø5 × 4 mm
• 4 × M3 × 10 mm socket-head screws
• Optional glue for the feet

Suggested Print Settings

• Layer height: 0.12–0.20 mm
• Walls: 5
• Infill: 15–25%
• Material: PLA or PETG
• Supports: Required internally depending on print orientation
• Brim: Optional

Assembly

1. Print the enclosure, rear cover and feet.
2. Remove the original driver and cable from the Creative Inspire T6300 housing.
3. Install the driver inside the printed enclosure.
4. Route the cable through the rear cable opening.
5. Install the heat-set inserts.
6. Attach the rear cover using M3 screws. Before pressing the back cover fully into position, check that all four screw holes align correctly with the threaded inserts. Rotate the cover if necessary and do not force it into place.
7. Press-fit or glue the feet into place. Important: The feet are not interchangeable. Each foot is designed for a specific corner, so test the fit and confirm the correct position before pressing or gluing them in place.

Important

This is an independently designed replacement enclosure and is not an official Creative product.

Before printing, verify that your speaker driver matches the dimensions shown in the model images.

Designed specifically for the original speaker driver from the Creative Inspire T6300.

The original driver does not appear to be sold separately as an official spare part. Complete replacement T6300 satellite speakers can sometimes be found second-hand or as unused spare units.

Generic 50 mm drivers may not fit without modifying the mounting geometry, impedance, power rating and enclosure.