HotRod Cyberbrick - RatRod V8 - RC Car

Hello everyone, here is my latest CyberBrick model. This HotRod is equipped with a V8 engine that you can spin with your remote control

It works with the official CyberBrick remote control, you will need to purchase a few extra parts to assemble it, you will find the complete list in the bill of materials at the top of the page

I chose to use the N20 geared 1000 rpm motors for better top speed and because you can swap them without any modification with the N20 400 rpm motors, if you prefer torque over speed

The .Json programming file also includes front and rear lighting as well as V8 rotation. Magnets are placed on top of the engine so you can open it to admire the pistons moving up and down

Under the car, a small cover is clipped on to access the battery cable for recharging without disassembling anything. The tires are printed in Bambu TPU 85A. ATTENTION! Do not print them with a harder material such as TPU for AMS as this will not fit

I have written a complete assembly guide to assist you during assembly and I remain available if you have any questions

ATTENTION : On the H2 profile, you will find 2 versions: 1 that uses support filament and 1 with default supports, if you use the support filament print profile without specific filament, your supports will be impossible to remove

+ Added an offset washer for the front LED splitter mounting screw and updated assembly guide

Happy printing