Search models, users, collections, and posts
Droop Gauge and Stands - RC Racing 1:8 Scale
IP Report
Print Profile(2)
AMS & Non-AMS | 0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
2 plates
A1 Mini - AMS & Non-AMS | 0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
2 plates
Open in Bambu Studio
Boost
15
38
14
1
56
45
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
Droop Gauge – 1/8 Scale RC Buggy & Truggy Setup Tool
Inspired by the Tekno TKR3701 measurement concept, this is an original design created from scratch without reference dimensions. It's a must-have to dial-in droop quickly on 1/8 scale buggies and truggies. PETG recommended (PLA works but avoid prolonged heat exposure).
Assembly: Each stand uses one M3×20mm cap head screw and a locking nut.
How to Use
- Open stands on flat surface or setup board and sit car on stands with the wheels off.
- Set the gauge on the flat surface beneath the hub
- Read the droop measurement directly from the gauge
My Setup (Reference): Front: 0mm | Rear: −5mm (both buggy and truggy)
Design Notes
6/22/26: Redesigned stands for strength, reduced sharp edges, easier nut installation
6/23/26: Added print profiles (both AMS and Non-AMS versions included)
6/25/26: Added A1-Mini profile per request
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (14)