Organic Elegance – Leaf Phone Holder

Organic Elegance – Leaf Phone Holder

A decorative phone holder inspired by flowing branches and layered leaves. The open botanical design keeps the model lightweight while providing a stable base and comfortable viewing angle for your phone.

It works beautifully on a desk, nightstand, kitchen counter, or anywhere you want a practical stand with a softer, nature-inspired look. The detailed cut-out pattern is designed to print cleanly while keeping filament use relatively low.

Current size fits both smaller and larger smart phones. Current height is ~17 cm (~6.7")

Filament used for the model in the image: Matte Green PLA (GEEETECH)

Printing

• Use a clean print plate with some glue (unless you are using a super tack plate)
• Use dried out filament
  • (Different filament types impact the print differently, please adjust your settings accordingly. If printing with silk PLA, then I recommend to adjust the Speed Outer wall setting to 40mm/s and Tope Surface to 40mm/s.

Support Removal:

1. Let the model cool down before removing the supports.
2. Use pliers when removing the supports.
3. Start with breaking the support in the middle  by “crushing” them by using a plier. This helps loosen the structure before removing the supports.
4. Move to the top and work your way downward.

Light sanding and gentle, controlled heat may be needed to clean up areas where the supports were attached on the backside. I used a handheld mini torch, but apply heat carefully to avoid warping or damaging the print.

If you like this design, please leave a rating, a comment or a boost.