Clicker Fidget

🖱️ Mini Clicker Fidget

This fully 3D-printed clicker fidget is designed to print in one piece with no hardware, magnets, springs, or assembly required.

Features

✅ Print-in-place design

✅ No hardware required

✅ Approximately 7g of filament

✅ About 20 minutes to print

✅ Compact pocket-sized design

Important

⚠️ Allow the print to cool completely before using it. Attempting to click it while the plastic is still warm may cause the mechanism to stick or deform.

Printing Notes

• PLA recommended
• No supports required
• Tested on Bambu Lab printers
• Works best after cooling and freeing any small fused areas

Thanks for checking out the model! If you print one, feel free to leave feedback, share your results, and suggest improvements for future versions.

Fast and lightweight print profile optimized for reliability.

Uses approximately 7g of filament and prints in about 20 minutes. No supports, no assembly, and no additional hardware required.

⚠️ Be sure to let the print cool completely before using the clicker mechanism.