Search models, users, collections, and posts
Window Cleaner Monitor Buddy
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
7
16
0
0
6
3
Released
Description
Window Cleaner Monitor Buddy
Meet your monitor's new best friend!
This little window cleaner hangs right off the top corner of your screen,
adding a fun, creative touch to your desk setup.
I used a double sided tap to attach
IMPORTANT: Print & Post-Processing Warning
- Difficulty Rating: 8 / 10
- Support Removal: Proceed with extreme caution! This is a challenging print to clean up.
- Delicate Zones: There are a few very fine, delicate areas that can easily snap if you rush the support removal. I have added some subtle reinforcement to these zones, but adding any more would have ruined the clean aesthetic of the model.
Pro-Tip: Take your time, use flush cutters (side cutters) rather than pulling, and be incredibly gentle when peeling supports away from the fragile parts.
If you manage to print this successfully, please post your makes and share in the comments! Happy printing!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)