Meccha Chameleon Characters - All OG Poses (No AI)

Just a fun side project, I tried to make them as accurate as I could to the game, no AI was used to make them! They print best orientated up-right with supports where needed. The base scale is around 80mm tall, but can easily be scaled up if you want them even bigger!
I also made small flats on the bottoms of the feet to make them print better and so they can stand up on their own (not super stable though).

----------------------------------------------------------------------

Update 06/25/2026

The new set of poses added in the 06/24 game update are now available!

You can find them here:

https://makerworld.com/en/models/2976261-meccha-chameleon-characters-set02-still-no-ai#profileId-3338654

----------------------------------------------------------------------
Update: 06/24/2026

Added a Flat Backs profile for easier printing if you have trouble with them standing upright. They are mostly 1-sided as the backs are cut to be flat with no supports on most poses. The surface quality won't be as nice in this orientation, but they'll be very easy to print with no worrying about bed adhesion.

I also updated several profiles to lower the models below the plate slightly. This does cut off the feet little more (a fraction of a mm) creating a bigger flat spot, but it increases the surface area that contacts the plate. This should help those that have bed adhesion problems causing the prints to get knocked over, especially for bed slingers.

I also added custom painted seams and supports for some poses and "fixed" the non manifold edges.

I highly suggest making sure your build plate is clean with soap and water, and that your filament settings are tuned to the correct temperatures to increase bed adhesion.

----------------------------------------------------------------------

Want magnet versions? Check out the parametric magnet versions available here:
https://makerworld.com/en/models/2962403-meccha-chameleon-character-magnets-parametric#profileId-3320917