Gallade - Multipart - no AMS - Full separation

Hello Pokelovers!

Take a look at my newest multipart of existing model by AShu.

For the advice according to multipart models please take some time to visit my other works - there are a lot of useful remarks.

According to this guy, apart from other common points, please print the parts really slow for good quality. I did not test bigger size. Face just clicks in - don't be afraid to use something to get rid of excess material if needed, model is small and detailed around the face so it was hard to separate. I printed at ‘Silent’ mode most of the parts and used AMS eyes - separation was also test printed but not used. Filaments are the ones selected in the profile.

In case of any questions/suggestions please comment! If you want and like the multiparts/models please consider boosting - points always motivate to post/share.