Sheep Figurine & Stand | No AMS | Fuzzy Skin

Check out my new models from Fuzzy Animals series:

Capybara

-------------------------------------------------

🟢 Let the build plate cool down before removing your model so that supports and brims come off cleanly. 🟢

This is the sheep figurine from my Fuzzy Animals series. They can be printed without AMS. If you AMS, there is a print by object profile for fast printing. You need to super glue in the face, eyes, nose, ears, and the feet. The model's left eye and left-side parts are marked with an “L” or a dot, model's right eye and right-side parts are marked with a “T” or are unmarked (no dot). After applying the glue and inserting the feet, make sure to put the model on something flat like a table so that bottom ends up flat after the glue cures. They are quite small so be careful. I would recommend applying the glue to the slots, not the parts since that's easier.

The profile settings are carefully tuned, do not change them, as this may cause issues. Let the build plate cool down before removing your model so that supports and brims come off cleanly.

Do you want to sell 3D prints of my designs or support my work? Join my commercial membership on Patreon 🎉

Figurines are roughly 60mm in height not including the ears. They come with an optional stand. They have a connector at the bottom for connecting to the stand. You can optionally use them with ⌀6 × 2mm magnets for connecting to metal surfaces, or other magnetic stands.

All left-side parts (model's left) are marked with an “L” or a dot, all right-side parts (model's right) are marked with a “T” or are unmarked (no dot).

---------------------------------------------------------

Here is the rest of the Fuzzy Animals series, including the ones that I'll upload in the upcoming weeks. Follow my profile to get notified:

----------------------------------------------------

Here are your options for the connector and its dimensions in case you want to create your own stand:

Mount Option 1: Leave the connector as is to use with non-magnetized stands.

Mount Option 2: Super glue three ⌀6 × 2mm magnets together. Then glue them to the slot.

Connector Dimensions: 6.3mm wide, 6.4mm deep octagon with 0.4mm side fillet, and 0.4mm entry chamfer.

----------------------------------------------------

Here are your options for the stand:

Connector Option 1: Apply super glue to the bottom of the pin, apply super glue to the pin slot and insert the pin.

Connector Option 2: Super glue two ⌀6 × 2mm magnets together. Then glue them to the slot.

--------------------------------------------------

Check out my other models from the Fuzzy Animals series:

Mouse	Moose
Wolf	Cow
Duckling	Penguin