bubble making wind twirler garden flower vane

A fun print to add a little decor to your garden area or lawn. I made this to give a little fun to my kids and let them play with a bubble maker powered by nature.  Just fill it with your own bubble mixture and watch it create bubbles floating with the wind.

INSTRUCTIONS:

WHEN ASSEMBLY BEGINS START WITH THE MAIN BEARING CASE. INSERT THE BEARINGS IN THE BEARING SLOTS AND BEGIN TO FEED THE BUBBLE WHEEL INTO THE BEARINGS. ONCE YOU GET THE BUBBLE WHEEL'S SHAFT DEEP ENOUGH TO ADD THE RETAINING RING TO THE SHAFT. AFTER THAT ENCLOSE THE MAIN BEARING CASE WITH THE UPPER SECTION. THIS IS A GOOD TIME TO ADD THE O-RINGS TO SECURE THE CASE. THE WHEEL SHOULD BE ABLE TO SPIN FREELY. THE NEXT STEP IS TO ADD THE BUBBLE FLUID HOLDER. THIS IS WHERE YOU WILL NEED THE M3 SCREWS AND NUTS W/WASHERS. GENTLY ASSEMBLE THE BOLTS WITH THE FLUID HOLDER WITH THE UPPER CLAMP ON THE FRONT OF THE CASE. IT IS BEST TO GET THEM ALL STARTED BEFORE TIGHTENING THEM. HOLD THE CLAMP BACK ON THE CASE AND TIGHTEN ONLY FINGER TIGHT. NOT MUCH TENSION IS NEED TO KEEP IT IN PLACE. CHECK THE WHEEL AND MAKE SURE IT IS FREE SPINNING.  NEXT IS TO ADD THE BACK WINGS, THIS IS EASY TO ASSEMBLE BY PLACING THEM TOGETHER AND ADDING THE O-RING TO HOLD TOGETHER AND GENTLY SLIP THE TWO PIECES OVER THE END OF THE BEARING CASE. ONCE YOU GET FULLY ASSEMBLED AND MOUNT OR STICK THE MOUNT INTO THE GROUND JUST PLACE THE ASSEMBLY INTO THE MOUNTS HOLE AND ENJOY. 

YOU CAN ADD THE BUBBLE JUICE AND WATCH THE BUBBLES BLOW