Milwaukee M12 Subcompact Combo Packout Insert

This is specifically for the Milwaukee M12 tools 3540-20 (driver) and 3401-20 (drill), designed to fit a Packout 48-22-8435

This is a custom 3D-printed organizer insert designed specifically for the Milwaukee M12 drill and driver kit. It provides a perfect fit for your tools and batteries inside a standard Packout organizer.

Compatibility

• Tools: Milwaukee M12 Impact Driver (3540-20) and Hammer Drill (3401-20).
• Kit: Fits the complete Milwaukee 3494-22 kit set, including the tools and accompanying batteries.
• Organizer: Designed precisely for the Milwaukee Packout Organizer (48-22-8435).

Print Profiles

Two version types are included to match your printer's build volume:

• Full Version: Single-piece prints designed for larger printers (such as the H series or A2L).
• Split Version: Divided into smaller sections to fit standard-sized 3D printers. These pieces use interlocking dovetail joints for easy alignment and gluing post-print.

Material Recommendations

Due to potential heat buildup inside enclosed toolboxes, material selection is important.

• Recommended: PETG, ABS, or ASA. PETG performs well in moderate environments without warping.
• Not Recommended: PLA is highly discouraged, as it can easily deform under standard vehicle or job site temperatures. Choose your filament based on your local climate and sun exposure.

Helpful Add-ons

If you store small parts in the top sections and experience them spilling over, consider printing a lid gap filler to seal the container completely. You can search Makerworld for Milwaukee Packout Organizer Lid Gap Filler, there are a few different options from other makers.