Typ-2 holder for Pipe

My Father needed a Holder for his typ 2 Car charger, but all Models on Makerworld needed to be drilled into the wall, which wouldnt work for me, since our wall is not made for screws. So this is why I made this Charger holder, that you can put onto standard drain pipes.

There is a wiggle room at the screws for the holder, since when I made then bit thiker the stress seemed to break a screw easily. so this new one is sturdier.

When you print it, print as followed:
Cap Holder: TPU 5% infill, 2Wall
Screews and Nuts: ABS/ASA 100% Infill, Everything else default
Holder: ABS/ASA 45%, Supports tree - default, Rest default

Pipe Clambs: ABS/ASA 100% Infill, Rest default 

If I should include a thicker screw, just write in the comments or send me a DM. I will then add it in this model here and send you a DM