ASUS RT-AC68U or TM-AC1900 Wall Bracket
Print Profile(1)
Description
This is a wall mount bracket for either the ASUS RT-AC68U or the T-Mobile rebranded TM-AC1900.
This bracket mounts the router at a 90 degree angle to the wall, so that ethernet cables can be routed out without a tight 90 degree turn on exit.
I printed at 0.20mm layer height and 25% infill, and it is VERY sturdy; If I hung a weight on it, I think the router would break before the mount failed. Simulated loads 10x over the router weight were nowhere close to failure.
The mount holes are sized for ANSI-Inch #8 countersunk screws, though 4mm countersunk screws should work as well.
To install, mount the bracket to the wall, then slide/press the router into the bracket. It is meant to be a press fit, so it will be a bit tight to start; this is intended, and once started it will slide in a bit easier.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including, but not limited to, publishing derivative works outside the Makerworld platform or hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money or collect fees. Subject to the above restrictions, derivative works may be published only within the Makerworld platform, and all such derivative works must be licensed under the same SDFL‑C license, without modification or additional terms. You may download the digital versions of this object, 3D print it, and display images, videos, or usage demonstrations of 3D printed versions of the object on personal social media platforms or Makerworld official channels, provided that no digital versions of the object are shared or distributed.
Comment & Rating (0)