Hi-Point C9 & CF380 accessories/improvements pack

Accessory and improvement pack from the EBT project for all Hi-point C9 and CF380s, oem or printed. Just delete what you don't want to print from the 3mf and go.

Some parts may work with the YC9.

+2 magazine floor plate

Uses the OEM 8 round spring and gives you 10 rounds. Very reliable with the printed follower. The OEM floor plate just prys off with a small flat blade screwdriver, you will see a little tab on each side of it. Just pry up while pointing it away from you. The printed floorplate just snaps on like OEM, but usually not more than once or twice before the plastic tabs round over, and you will need to reprint it.  

Charging handles

Uses the OEM rear sight hardware and mounts in the rear sight pocket. If you are missing those screws they are 4-40 thread and about 5/16” long.

Magazine release buttons and loader

OEM replacement button if you lost your, and 3 other extended/larger options, tpu works well for these although you may need to scale them down 1% or more for a tight fit with tpu. 

Magazine follower

This fixes a lot of issues with unreliable LRHO. It also won’t tilt like the OEM metal follower.

Pic rails sight pocket mount

Uses the oem rear sight hardware (4-40x5/16” screws).

RMR mount

Mounts with the oem rear sight hardware (4-40x5/16” screws). You will need 2, M3x8-12mm screws and nuts. Length depends on your exact optic. These need to be loctited, or at least use nylon lock nuts, and check them often. 

Safety cover

This makes a surprisingly big difference in comfort when working the safety. It just presses on, if it's too loose/tight, scale it accordingly. Or just glue it.

Triggers

There is an OEM version and a flat face. You will need to drill out the pivot hole with a 1/16” drill bit.