Freedom 250 Fighter Jet HueForge
Print Profile(1)
Description
Boost Me (for free)
If you like this model, a 5-star rating and Boost would be genuinely appreciated. It helps support future designs and keeps new uploads coming. If you would like anything specific, please reach out and ask!
A Freedom 250 commemorative design built around forward motion and air-power styling, with a fighter jet breaking across oversized 250 numerals, red launch streaks, five-star detailing, and a stark black field for a clean patriotic display.
Print Settings:
- 100% infill
- 0.08mm layer height
- 0.16mm base layer
Print at 100% infill.
With a layer height of 0.08mm and a base layer of 0.16mm.
Filaments used:
- PLA BambuLab Basic Black
- PLA BambuLab Basic Jade White
- PLA BambuLab Red
This print uses 3 unique filaments.
Similar filament colours may be used, including close Bambu Lab or equivalent alternatives, but results may vary depending on filament brand, colour, transparency, and calibration.
Swap Instructions:
Start with Black.
At layer #14 (1.2mm), swap to Jade White.
At layer #22 (1.84mm), swap to Red for the rest.
A few small tips with the hueforge prints
- Set your filament temps to 10c lower - I run them at 210c on my H2S with bambu filament
- If you want to resize, ensure that that you uncheck uniform, and only scale the X/Y, leave the Z height as it is
- Ensure detect narrow internal solid infill is off
- Resizing!!! If you want to adjust the sizing of any of the hueforge prints, ensure that you unselect “uniform scale”, and only modify the X & Y axis, the Z axis MUST remain the same
- If you have any questions, or want some changes, or some feedback please leave a comment and I'll do my best to respond
Setting your retraction length to ½ of what it currently is will reduce stringing (can be found under the extruder tab within printer settings)
License
Comment & Rating (0)