Airless 5x5cm PLA ball
Print Profile(1)
Bill of Materials
Description
This ball is intended for throwing back and forth
It has the following printing properties:
- 20% infill (for higher stability)
- 4 walls (for higher stability)
- 0.2 mm layer height
Important: this is not a stress ball but intended for throwing
Printing instructions:
- I printed it without supports, it did not have the best print quality but removing the supports inside the ball would have been extremely difficult
- My print was done with PLA, but with PETG or TPU it would probably also work with the corresponding settings
Note on support removal:
There is only one support marked in the picture, please remove it, then the ball is ready for use:
Once you have done that, it should look something like this:
(If it doesn't come off completely, only remove what you can)
Have fun with the model
If you like it, follow me, leave a thumbs up and boost it
Also check out my other models:
Feel free to write to me what you think or if you have any questions
If you like it, give the model 5⭐️⭐️⭐️⭐️⭐️, follow me and leave a Boost 🚀
Boost Me (for free)
If you like this model then boost it🚀
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)