Pharaoh Ramesses: The Awakening of the Undying Sun

The Story / Lore

For three thousand years, he slumbered beneath the shifting sands of the Valley of the Kings. Entombed within layers of sacred linen, protected by deadly curses, and forgotten by time. But the eternal Pharaoh has awakened. He is no longer a mere mortal king, but an undying force of the underworld—half-mummified, half-skeletal, holding the ancient power of the sun and death within his glowing eyes. With his majestic Nemes headdress still gleaming through the dust of centuries, Pharaoh Ramesses rises to reclaim his fallen empire.

Are you brave enough to summon this ruler of the Nile to your print bed?

The Immortal Trio (Matching Models)
Yes, this is a long print, but the breathtakingly detailed result is absolutely worth every single minute!

Pharaoh Ramesses is part of an exclusive, terrifying series of undead historical rulers. Complete your collection and check out the other models available on MakerWorld:

• Cleopatra: Cleopatra - The Undying Queen 𓋹
• Julius Caesar: Julius Caesar - The Eternal Dictator 🏛️

Print Settings & Recommendations

• Height: 16 cm (Recommended minimum size!)
• Layer Height: 0.16 mm (Tested and recommended for the perfect balance between print time and incredible detail).
• Infill: 6% Gyroid
• Painting: Hand-painted with acrylics (The model features prominent 3D-printing texture layers which give it an incredibly authentic, hand-carved stone and bone look when dry-brushed or painted!).

⚠️ Crucial Size Warning: Please do NOT scale this model down! If printed smaller than 16cm, it will become extremely difficult to remove the organic supports inside the mouth cavity without damaging the teeth. However, scaling it UP is highly encouraged—the larger he is, the more powerful and majestic his presence becomes!

Note on Quality: You can print this at 0.20mm layer height to save some time, but at the current 16cm scale, some of the finest skin, bone, and fabric textures will lose their sharpness. 

⚠️ ATTENTION: Post-Processing & Bed Adhesion

1. Support Removal: Please proceed with absolute PATIENCE. Do not try to rip off the supports by hand. Use a small flush cutter (Seitenschneider) to carefully clip the support connections, especially around the delicate mouth, teeth, and beard areas.
2. Bed Adhesion: Make sure your build plate is deeply cleaned and free of oils before starting. Due to the majestic posture and height of the bust, perfect first-layer adhesion is vital.