X2D, P2S Dedicated Print-Only Magnetic Quick-Release Air Inlet Filter Device

The original author Dream Prop Studio mentioned needing filter cotton of about 15ppi, which is very close to 40% helical infill Actual tests show it doesn't significantly affect airflow, and the filter density is sufficient to block mosquitoes, particulate dust, etc, also avoiding issues like spaghetti supports For aesthetics, the original cutouts were retained, mimicking the space for filter cotton, but theoretically, it could be changed to full infill to maximize airflow Please note that at this 40% density, the blocking effect for fine dust is probably not as good as filter cotton, but it is sufficient to block small bugs, debris, hair, and other dirt Be sure to print according to the print profile, and it's best to check in Bambu Studio whether the first layer's infill lines are perpendicular to the cutouts Otherwise, it will string in mid-air, which looks bad
 
 

No ill will intended, it just so happens that a friend wanted to get this model Since the author doesn't like to have it listed as a profile under his model to earn points, then I will follow the author's open MakerWorld Exclusive License

Now I'm listing my own re-developed model on MW Given that the author blocked me, I have declared the author according to the MWEL agreement and will not engage in further communication

Due to the separation of the international and China sites, the model was resynchronized from the China site, losing its past reviews and other data Please understand