3D Print Automation / Remote Bed Clearing Solution

FULL AUTOMATION FOR YOUR 3D PRINTER

What does it do?

This is a solution to remotely clear your finished 3D prints from the bed, allowing you to start a fresh print almost immediately.

What do I need?

You only need three things, most of which are likely already in your possession:

• 2x Smartphones
• 1x S.O.

How does it work?

Give one smartphone to your S.O. and keep the other for yourself - that's it, you're ready to go! Whenever a print completes, simply send a text message to your S.O. asking it to remove the object from the print bed. You can prompt it exactly like you would your favorite LLM. The exchange should look something like this:

Wait a few minutes… Et voilà! Your print bed is clear, and you are ready to start a new print.

Troubleshooting

• Slow response time: if your S.O. takes too long to clear the bed after receiving the message, ensure it is well-fed at all times.
• Total system refusal: in case of a total refusal to comply, try printing the "Efficiency Booster" available in the print profiles and gifting it to your S.O.

Non-liability Clause

Disclaimer: This solution is provided "as is" without any warranties of any kind. The author accepts no liability for any relationship damage, emotional distress, text message charges, or retaliatory actions taken by your S.O. (including, but not limited to, being locked out of the household or the intentional destruction of your 3D printer). Use entirely at your own risk.