Simple mold for 50mm - Pillar candle / Candle

• simple mold for a pillar candle
• approx 80mm high, 50mm diameter
• a candle of this size can burn for up to 12 hours
• the two parts are held together with clips
• the candle wax must not be too hot, otherwise the mold will warp, 60 degrees is perfectly sufficient
• pour the wax slowly in several layers
• a funnel with a centering aid for the wick is included as another stl file

*Here is an affiliate link to a candle making accessory set: https://amzn.to/4up7dLa

We tried it and it includes everything needed

*… and here are the clips: https://amzn.to/4vGuFol

Disclaimer:
* - some external links contain affiliate data. If you order something through these links, I will receive a small commission to supplement my pension, it will not cost you anything extra.

Thank you very much.

Please note: The quality of the print has a lot to do with well-dried filament and a very clean print plate. Please check your printing environment and adjust the print bed and nozzle temperature to your filament.
The models shown here are printed exclusively with Bambu Lab P1S.

*Filament dryer: https://amzn.to/4e4uEVr

*Container for storing filament spools: https://amzn.to/4eyK6sQ - the filament spools fit perfectly inside

*Silica - Granulate - https://amzn.to/4fxnWbx - I use 40g per container (4L), if the granules have become dark due to humidity, they are dried in the oven at approx. 70 degrees, they turn orange again and can be reused over and over again

*Bambu Lab P1S 3D Printer: https://eu.store.bambulab.com/products/p1s?from=navigation