Storage Canister 250g – Push-Fit Lid Ø95 x 134 mm

Minimal Storage Canister 250g – Push-Fit Lid Ø95 x 134 mm

A simple and minimal storage canister for dry goods such as ground coffee, sugar, flour, salt or similar everyday kitchen items.

I designed this container for storing ground coffee powder, and it works very well for that purpose. It holds up to approximately 250 g, depending on the material you fill it with.

The lid uses a firm push-fit connection and sits securely without needing threads or additional hardware.

The design is intentionally simple, clean and fast to print. No decorative pattern, no complicated mechanism.  Just a practical storage container for a fixed place in the kitchen, office or pantry.

Dimensions

• Outer diameter: 95 mm
• Height: 134 mm
• Lid type: push-fit / press-fit lid
• Designed capacity: up to approx. 250 g, depending on the filling material

Important note

This container is intended for dry goods only.
It has not been tested for liquids, transport, shaking or airtight storage. Use it at your own responsibility.

For fixed placement and dry contents such as coffee powder, sugar, flour or salt, it works without issues.

Recommended print settings

• Layer height: 0.24 mm
• Walls: 2
• Infill: 10%
• Supports: No
• Brim: Not required, unless you have bed adhesion issues
• Material: PLA or PETG

The push-fit lid should sit firmly but still be removable by hand. Depending on your printer and filament, the fit may vary slightly.