Search models, users, collections, and posts
Charge Port Cover for E-Bike with Rosenberger
Remixed by
IP Report
GIF
GIF
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
40 min
2 plates
Open in Bambu Studio
Boost
0
1
0
0
0
0
Released
Description
Content has been automatically translated.
The original model (thanks to @Philipp17) was adapted and slightly scaled down; a tab was added to lift the cap and an attachment was included to prevent it from getting lost during charging. Magnets were added so the cap stays on the charging port
It was printed in TPU 95A
The cover is suitable for all Ampler Gen 2 models and other e-bikes with Rosenberger C-connectors
Important: The attached print profile includes a pause before layer 38 (print plate 1) or layer 40 (print plate 2) to allow for the insertion of two 5x2 mm magnets; these are based on magnets from Gizeh Papers. Ensure that the magnets are placed with opposite polarities so that the cover securely attaches to the bike
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)