Donald Trump – Minimal HueForge Portrait

Turn filament into graphic art with this original Donald Trump HueForge portrait.

I created this artwork using bold geometric shapes, deep shadows and a limited color palette to produce a clean, recognizable portrait. The vertical composition and integrated DON’T typography give the model a modern poster-like appearance that works well as wall art, desk decoration or part of a political-art collection.

The red layer creates a subtle accent between the black and white sections. You are not limited to the original palette—you can swap the colors to match your own style, room or filament collection. Try gold instead of white, blue instead of red, or create a monochrome edition.

The model prints flat, requires no supports and is designed for fine detail at a 0.08 mm layer height.

Please share your color combinations and finished prints in the community section—I would love to see how you reinterpret the artwork.

Model Specifications

• Model size: 74.93 × 160 mm
• Actual thickness: 2 mm
• Maximum allowed thickness: 2.24 mm
• Base thickness: 0.48 mm
• Layer height: 0.08 mm
• Base layer height: 0.16 mm
• Infill: 100%
• Supports: Not required
• Unique filaments: 3
• Recommended nozzle: 0.4 mm
• Print orientation: Flat on the build plate

The model may be printed using a higher layer height only for the layers below the 0.48 mm base thickness.

Filament Setup
The included profile uses four visual color stages with three unique filaments:

1. Bambu Lab PLA Basic Black
2. Bambu Lab PLA Basic Red
3. Bambu Lab PLA Basic Jade White

The supplied HueForge settings use the following filament characteristics:

• Black: #080A0D - Transmission Distance 0.3
• Red: #C00D1E -Transmission Distance 4
• Jade White: #FFFFFF -Transmission Distance 5

Color-Swap Instructions

• Start with Bambu Lab PLA Basic Black
• At layer 10 -0.88 mm: change to Bambu Lab PLA Basic Red
• At layer 13 -1.12 mm: continue with Bambu Lab PLA Basic Red
• At layer 16 -1.36 mm: change to Bambu Lab PLA Basic Black
• At layer 18 -1.52 mm: change to Bambu Lab PLA Basic Jade White for the remaining layers

Printing Without AMS

The model can also be printed without an AMS by adding manual pauses at the listed layer changes and replacing the filament by hand.

This is an original artistic interpretation created specifically for 3D printing. The model is intended for personal, non-commercial use unless additional permission is provided.

✨ Boost Me!
If you found this useful, consider boosting — it really helps support more free designs!