Cup Holder Gun Holster

A pistol holster that fits in your cup holder.

• 1st Print profile fits S&W Shield .45 caliber & SCCY CPX-2 9mm or similar-sized pistol

• 2nd Print profile fits the Springfield XDS .45cal/9mm or similar

• 3rd & 4th Print profile fits Glock 23/19/43X (.40cal/9mm) or similar

• 5th Print profile fits Sig P365 XL 9mm or similar 

• 6th Print profile fits Walther PDP Compact 9mm or similar

• 7th Print profile fits S&W M&P M2.0 9mm or similar

• 8th Print profile fits Springfield Hellcat 9mm or similar

• 9th Print profile fits  Sig P365/P365 SAS .380/9mm or similar

• 10th Print profile fits S&W MP Shield M2.0 EZ 9mm or similar

• 11th Print profile fits Kimber 1911 Ultra TLE II 3" (.45/9mm) or similar

• 12th Print profile fits TAURUS GC3(9mm/.40cal) or similar 

It fits the cup holders in 2014-2018 Chevy Silverado and most other vehicle cup holders. If it can hold a standard-size coffee travel cup, it will fit. 

There is a wide-body version plate for all models, used for trucks/cars that have those extra-large cup holders.

I have added an option to install magnets if extra retention is preferred.

All models have 4 plates: one without magnets, one with magnets, and 2 with both models with no words embossed. Most profiles also have a 5th or more plates with Wide or Taller versions of that selected model for extra large cupholders.

The magnets used are 40mm x 10mm x 3mm. They are a snug fit; glue is not required. 

It's rare, but if it's too tight of a fit and the magnets aren't going in, you might have to compensate for shrinkage, depending on the filament used. Magnets' manufacturing tolerances can be slightly off too. Putting the magnets in the freezer for a few minutes, then installing them immediately, can help.

If I made the holes any bigger, glue would be required to keep them from rattling around or falling out.

Install the magnets inside the two small slots on the top front end of the Cup Holder Holster.

Push the magnets into the slots until flush. Use a piece of wood, something hard, the table,etc. if its too hard on the fingers. Then finish by using a small flat-bladed screwdriver or similar to push them all the way down until they stop.

Then you can cap the holes with the plugs if you'd like; it isn't required, it just looks better. Glue isn't required for these as well; snug fit. 

If you need an extra mag holder to go along with your cup holder holster, go here-→

https://makerworld.com/en/models/3029514-cup-holder-magazine-pouch#profileId-3404733