Aluminum magnetic Socket rail end cap

Sedy magnetic aluminum socket rail end caps (non working). I used the Sedy brand socket rail holders to organize my socket drawer. I discovered that I needed to cut several 16" rails in half to create 8" rails for smaller socket sets. Doing so I needed additional end caps. The factory end caps have a button you press to remove or add socket anvils. These are non working end caps. They are solid and screw in just like the factory ones but do not snap open. 

Printed on an A1, upside down with supports because I was having trouble with the tiny overhangs on the groove that slips inside the aluminum rail. Probably not needed as they worked either way. The lines just weren't as clean without supports. 

These should fit most aluminum magnetic socket rail organizers (Olsa, Sedy, Workpro, CXPro, Horusdy, Swanlake, Reniteco, ect). Might need some tiny #6 wood screws. I included a 1mm counter sunk hole for them.