Wall mount for Navee charger (1.3 A & 2.45 A)

Wall mount for Navee charger (1.3 A & 2.45 A)

A sleek and simple wall mount for storing your Navee charger. Besides holding the charger itself in place, you can also hang the cable and secure the plug – all organized in one place without tangled wires. The file contains two variants so you can print the one that fits your specific charger:

• 1.3 A – the smaller original charger
• 2.45 A – the larger fast charger

The mounts are designed for the European chargers of Navee GT3 and GT5. It's possible that the same charger is used for other models or in other countries, so it might fit more – but please measure your own charger to be sure.

Print Settings (suggestions)

• Material: PETG or ABS is recommended if the mount is placed where it might get warm; PLA works for regular indoor use
• Layer Height: 0.12 mm
• Infill: 25%
• Support: usually not needed (check with your slicer)

Mounting Screw the mount to the wall, or use double-sided mounting tape on a smooth surface. Then hang the charger, wrap the cable in place, and secure the plug in the holder.