Q903 race buggy body

This is a two part Race Buggy body I designed for the Q903 RC.

It improves cooling using the two ram air intakes on the top of the body to force air onto the motor and battery which is especially useful when running 3S batteries as it can get quite hot. It also allows for more personalization as you can paint it or use different filaments.

Instructions:

It prints into parts to reduce support waste and improve layer quality.

To connect the two halves apply a glue of your choice to each one of the connection points then press it together.

Filament: I find PLA works great because its low melting point allowing it to soften up a bit in the heat making it more shock resistant.