Sturdy and durable recessed Garmin compatible cycling computer mount for Bontrager Blendr system

The special design of this cycling computer mount, printed flat on its side, makes it sturdy and durable. This is a cycling computer mount I downloaded from Thingiverse a long time ago and have been using for a long time. However, there was an issue: while it worked fine with Garmin cycling computers, it was a bit too small for iGPSPORT cycling computers and wouldn't fit. I modified the dimensions to basically support any device on the market that uses a Garmin cycling computer connection port, including cycling computers and headlights.

Note:

1. Please use 100% infill
2. After printing, use super glue to attach the two side pieces to the main body.
3. The elongated lower support provides better strength; please glue it to the bottom of the main body.

Four years ago, I printed this cycling computer mount using PLA filament on an Ender-3 printer, and it has been in use until now (June 2026) without any issues. This method of printing flat on its side ensures strength in all directions. Please use it with confidence.

I believe using PETG will result in even better performance. The original author used it for at least 1000km without any issues, even without using super glue or reinforced lower support. When I first printed it, I used reinforced lower support and super glue, and encountered no problems.