Cut Link - For Broken Link on Cuban Hype Chain

Have you had a chain print perfect only to find one link failed?

A Patreon member had this happen and hope this will help "fix" that problem :) This happened to me today and felt this is could be helpful.

It is a tight fit and the link has to go in with the smallest edge.

-Place the cut link in one hand. Place your thumb on top and pointer and middle finger on the bottom. Like you are about to snap your fingers.

-Use your thumb and pointer finger to push up while using you middle and index finger to push in the opposite way or at least to anchor the opposite side.

-This temporarily widens the gap allowing you to insert the slim edge of link on chain through the gap. Be patient and take your time.

There are 2 tolerances.
-Single Link with cut - Wider Tolerance
-Single Link with cut - Smaller Tolerance

Each has a single color and striped version so you can try and match the chain it is for. Use the Project Filament section to select your colors.

Want to make your own cut link? Use my link cutter tool below!
https://makerworld.com/en/models/2924830-link-cutter-tool-for-broken-link-on-cuban-chain#profileId-3273435

Please share photos of your prints, would love to see them!! - :) 

For requests and commercial use with any of my models or to support me, subscribe to my Patreon!  Hope to see you there!

Patreon members get models before Makerworld, Hype Chain Requests, access to the Reliquary, Discord, and other exclusive benefits!

Also Great if you are new to the hobby and are looking for additional support and community!
Starts at $5 for personal use and $8 for commercial

-Ev