Reusable Cotton Pad Dispenser

Reusable Cotton Pad Dispenser — Makeup Remover Pad with Used Cotton Receptacle

A compact two-zone set for reusable (or disposable) cotton pads. It combines a bottom-dispensing dispenser for clean cotton pads and an adjoining receptacle for used cotton pads, bringing the entire cycle into a single object

Operation

Bottom dispensing Clean cotton pads are dispensed one by one through an opening at the bottom of the body. You take the bottom pad from the stack; there is no need to remove or flip the stack

Vertically removable lid The outer sleeve lifts upwards to refill the stack, then sits back in place

Indexing lug A small lug at the top fixes the lid's orientation, which always returns to the same symmetrical position relative to the dispensing opening

Receptacle for used cotton pads The adjoining compartment holds used cotton pads (a laundry bag is recommended) until the next wash

Non-slip pads The base has recesses for self-adhesive non-slip pads that stabilize the assembly

Parts to print

Two printed parts:

• Main block — single piece (dispenser body + receptacle)
• Lid — sliding sleeve

An alternative STL of the main block without the receptacle is also provided

Print settings

• Material: PLA or PETG
• Nozzle: 0.4 mm
• Layer height: 0.2 mm or less
• Supports: minimal
• Infill: standard

Accessories (not printed)

• Self-adhesive non-slip pads, 10 mm diameter (10.5 mm recesses)
• Washable cotton pads + small laundry bag

Support my creations

If this model is useful to you, you can support my work on Tipeee: https://fr.tipeee.com/davy-creation

Feel free to share your makes and feedback in the comments