Search models, users, collections, and posts
Swash Plate leveller for 500 helis with 8mm shaft
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 7% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
This tool can be used to align the swashplate of 500 size helicopters with 8mm main shaft.
On the original Align shaft it sits an bit tight, you might have to use a drill to widen it a bit.
Aftermarket main shafts are sometimes a bit undersize.
I printed with normal PLA in standard settings with support. It might be possible to print without if printed upside down.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)