Solar fountain

This 3D-printed solar fountain creates a small oasis of calm on your balcony, terrace, or in your garden. It is completely self-sufficient through solar energy and functions without an external power source

The wavy pattern on the outside of the model casts beautiful shadows in the sunlight. The model can be assembled in just a few minutes. The solar panel cable is routed inside the outer casing and is therefore almost invisible

Assembly Instructions

1. Preparation: Print all parts in a water-resistant material such as PETG, ASA, or ABS. PLA is less suitable due to UV exposure and constant moisture. To ensure the outer body is completely watertight, I additionally sealed it with DIAMANT dichtol
2. Place the pump: Insert the pump into the rectangular recess at the bottom of the outer body and guide the cable through the designated opening in the casing to the outside
3. Assembly: Insert the inner body into the outer casing and close it with the corresponding lid. Make sure that the pump's water outlet is guided through its designated opening. Finally, place the upper sealing ring of the outer body
4. Water on: Fill the reservoir with water, connect the solar panel, and place it in a sunny location

External Accessories:

I used the following solar pump for my fountain:

https://www.amazon.de/dp/B0GC62K3LV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

If you want to use a different pump, please check if its geometry and dimensions fit

I recommend using the fountain exclusively outdoors

Have fun printing and relaxing! If you like the design, I would appreciate a like or a photo of your finished fountain in the comments!