Super Mario Bros Fire brick-style - 500%

Super Mario has taken the fire flower!!!

He has transformed into the angrier and more evolved version with the throwing of fireballs!!!

LET'S FIRE!

INSTRUCTIONS:

• First of all, your printer MUST be well calibrated
• Recommended material PLA
• Total height of the model ~23.5cm
• There are few supports and if printed with basic settings, they are easily removable
• I have also added the brim in the small parts, but as a basic tip, always keep the print bed clean and degreased so you don't have adhesion problems. I haven't had any 😉
• All the pieces interlock and the movement will be "controlled" in case the pieces move too much I advise you to do some tests gradually increasing the size of the prints with steps of +0.5%
• Interlocking head components! No more prints lasting 15 hours or more! Mouth, eyes, mustache, ears, everything! Glue is needed to glue the head, hat, hair, and optionally the nose. The rest is interlocking! Interlock all parts BEFORE inserting them into the final head! It might be necessary to clean up some residues or print imperfections (it happened to me, it's normal!!!) - see attached GIF!
• The white part of the eye should be made with 1.75mm filament, inserting it into the black part of the eye: cut a small piece of white filament, heat one end with a lighter or any heat source and press it with the black piece, then remove the excess with wire cutters. I recommend cutting the “outside” part, see attached GIF!
• The fireball is, honestly, a bit ugly but I'm working to make it more contained and more beautiful as a final result, follow the next updates!
• The head is easily interchangeable with the smiling one from the classic version

Happy printing!