Flat Cable Screw Clip (2x0.75mm²) - Ceiling lamp

A simple 3D-printable cable clip designed for fastening flat lamp cable to a wall or ceiling.

I made this for a 2x0.75 mm² flat cable, commonly used for lamps. It is especially useful on concrete walls or ceilings where small nails are not an option, and you need to use wall plugs and screws instead.

The clip holds the cable neatly in place and can be mounted with a single screw.
I used a 3.5x30 mm screw with a head diameter of 7 mm.

Print notes:
Print flat on the build plate.
No supports should be needed.
PETG or PLA should work fine for indoor use.

Mounting note:
Designed for use with a small screw and wall plug. Make sure the screw head fits the countersunk hole before mounting.

Safety note:
Only use on cables that are in good condition and suitable for fixed installation. Do not overtighten the screw, as this may damage the cable. Always follow local electrical safety rules.