XGIMI Horizon 20 Tripod Base (Monoblock)

A clean, minimalist tripod hub designed specifically for the XGIMI Horizon series in two different Designs. It matches the projector's aesthetic perfectly and replaces bulky original stands with a sleek, modern DIY alternative.

Features

• One-Piece Print: Prints completely in one piece. No gluing and no screwing of the printed parts required.
• Easy Assembly: Print it, insert orings and the legs, and you're good to go.
• Custom Look: Choose wooden dowels for a warm Scandi look, or aluminum tubes for a clean, industrial tech style.

Bill of Materials (BOM) – What else you need:

• 3x Round wood dowels or aluminum tubes: 30mm diameter (length depends on your preferred height).
• 6x O-rings: Size 29.8 x 3.1mm or 30 x 3mm (locks the legs firmly in place and acts as a visual accent / non-slip foot).
• 1x 26mm Standard 1/4" tripod screw to mount the projector.

Print Settings

• Filament: Highly recommended to use filled filaments like PLA CF, PETG CF, ASA CF, or ABS GF for maximum stiffness and extra strength to securely support the projector's weight.
• Filament:
  • PLA-CF is highly recommended and works perfectly for standard indoor setups (provides extreme stiffness against leg splaying).
  • Alternatively, use PETG-CF, ASA-CF, or ABS-GF if you need higher temperature resistance (e.g., for very hot rooms, conservatories, or outdoor use).
• Nozzle Size: 0.6 mm (Highly recommended for fiber-filled filaments to prevent clogging and increase layer bonding).
   

Liability Disclaimer
Use at your own risk. This design has been tested, but printing results may vary depending on your printer and settings.
Make sure to use suitable materials, especially when using the bottle or lighting modules.
I am not responsible for any damage, misuse, or issues resulting from the use of this design.