Bohan N4 7-sided MLOK handguard assembly
Print Profile(1)
Description
I felt the original was a bit short, so I replaced it with a 280mm long one. I printed it vertically on a super large i3; I haven't tried tilted printing with the print size of an A1, as I'm afraid of failure. There are a few shorter ones inside that can be printed on an A1. For printing tall, thin parts, you must add a brim with zero separation. The handguard ring and screws can use the original ones. It is recommended to clone a handguard first. Slice a small section 2mm thick, put it on the toy to test if sinkage rate adjustment is needed, and scale the model size
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)