Tennis Ball Rocker Foot Left Wahoo Kickr V5

🇬🇧 Tennisball Rocker Foot (Left Side) for Wahoo Kickr V5

Since I could not find a suitable design with the tennis ball feet aligned parallel to the trainer's rocking axis, I designed my own version.

Required hardware:

• 1× M10 × 20 mm socket head screw 
• 1× M10 washer (DIN 125 Form A or equivalent) 

The tennis ball fits securely into the foot and is retained without additional fastening.

Depending on the tennis balls used and the desired amount of movement, spacers or shims may be required under the center support feet of the Kickr to ensure proper contact with the floor and even load distribution.

This model was designed and tested for the Wahoo Kickr V5. It may also fit the V6, but I have not verified compatibility.

Print settings

• Material: PETG 
• Printer: Bambu Lab P2S 
• Print time: approximately 4 hours per foot 

Matching right-side foot:

Tennis Ball Rocker Foot (Right Side) for Wahoo Kickr V5

🇩🇪 Tennis Ball Rocker Foot Left for Wahoo Kickr V5

Since I could not find suitable models where the tennis ball feet are aligned parallel to the trainer's rocking axis, I designed this version myself.

Required for assembly:

• 1× M10 × 20 mm hex socket head screw
• 1× M10 washer, Form A

The tennis balls fit positively and securely in the foot.

For the Kickr's middle feet, depending on the tennis ball used and the desired range of motion, spacers or shims may be required so that the trainer does not float on the middle supports or is unevenly loaded.

The model was developed and tested for the Wahoo Kickr V5. It is possible that the feet are also compatible with the V6, but this has not been verified by me.

Print settings

• Material: PETG
• Printer: Bambu Lab P2S
• Print time: approx. 4 hours per foot

You can find the matching right side here:

Tennis Ball Rocker Foot Right for Wahoo Kickr V5

Feedback and photos of your builds are welcome. I would appreciate a review if the model worked for you.