Search models, users, collections, and posts
6.35mm bit, screwdriver set, socket storage
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
0
0
0
0
0
0
Released
Description
Content has been automatically translated.
The first print designed through self-study, feedback from experienced users is welcome.
The first design didn't account for assembly tolerances, resulting in an assembly that was too tight to use.
Only then did I remember to make tolerance test pieces.
Ultimately, I measured that the appropriate assembly tolerance for the PETG filament I'm using is 0.3mm-0.4mm on one side.
This process is merely a self-study note.
Experienced enthusiasts are welcome to discuss.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)